What BCIT can supply for dynanometer testing
Dynamometer testing is available at the Motive Power Centre of Excellence on Annacis Island in Delta, BC
1. Engine dynamometer testing
- Sound attenuated enclosure room with computer controlled work station located outside booth. Bullet resistant viewing window for watching engine operating conditions. The room is equipped with a large passive exhaust system. This room has two 42 inch fans, 27,000 cfm at 0.250″ i.w.g. 460V, 3-phase to maintain approximately 20° Δ T
- 1000hp engine dynamometer with torque, RPM and horsepower readings. Programmable test cycles for accurate repeatability.
- Total of 16 pressure readings, pressure ranges as follows:
- Nine pressure readings 0-100psi
- One pressure reading 0-5psi
- One pressure reading 0-50psi
- One pressure reading 0-200psi
- One pressure reading 0-500psi
- Three pressure readings -14.7-100psi
- Total of 16 temperature readings using type K thermocouples
- Engine control Module (ECM) interface using common protocols J1708/J1587, J1939, OBDII, SAE J1850 VPW, SAE J1850 PWM, SAE J2284/ISO 15765 (CAN), ISO 9141-2 and ISO 14230-4. ELECTRONIC ENGINES ONLY
- ECM ignition supply for electronic engines
- Engine crankcase blow-by measurement
- Exhaust opacity measurement
- Exhaust gas emission monitoring using a Testo 350 emission analyzer. The 350 can measure O2, CO, NO, NO2, SO2, H2S, Hydrocarbons, CO2, pressure, temperature, flow, and velocity. NOₓ is calculated using NO and NO₂
Fuel management capabilities for Brake Specific Fuel Consumption (BSFC) readings
- The diesel fuel measurement unit (FMU) accurately measures the weight of diesel fuel in a beaker and calculates the rate of fuel consumption by continuously analyzing the weight of the beaker as the engine draws and returns fuel.
2. Chassis dynamometer testing
- Outdoor covered dyno area
- Taylor Eddy current chassis dyno for tandem drive vehicles
- Max 600HP (wheel HP) with programmable test cycles for repeatability
- Total of four pressure readings, pressure ranges as follows;
- One pressure reading 0-5psi
- One pressure reading 0-200psi
- One pressure reading 0-500psi
- One pressure reading -14.7-100psi
- Total of four temperature readings using type K thermocouples
- Engine control module (ECM) interface using common protocols J1708/J1587, J1939, OBDII, SAE J1850 VPW, SAE J1850 PWM, SAE J2284/ISO 15765 (CAN), ISO 9141-2 and ISO 14230-4. ELECTRONIC ENGINES ONLY
- Exhaust gas emission monitoring using a Testo 350 emission analyzer. The 350 can measure O2, CO, NO, NO2, SO2, H2S, Hydrocarbons, CO2, pressure, temperature, flow, and velocity. NOₓ is calculated using NO and NO₂
Fuel management capabilities for Brake Specific Fuel Consumption (BSFC) readings (DIESEL ONLY)
- The diesel fuel measurement unit (FMU) accurately measures the weight of diesel fuel in a beaker and calculates the rate of fuel consumption by continuously analyzing the weight of the beaker as the engine draws and returns fuel.